Brooch

A 1-post collection

Building Bitzer part 6 Adding the brooch backing was a relatively simple process, when compared to refining the front! The brooch backs cost...

Building Bitzer part 6

Adding the brooch backing was a relatively simple process, when compared to refining the front!

The brooch backs cost $2.49AU, which is one cent cheaper than the horrible tiny thing I’d have had to disassemble from a dollar shop. Remember, kids, it pays to look around and compare prices and options.

I had the shakes fairly bad, which made lining up the brooch back while I sharpies the dots in a little problematic, but as you can see, the rest went off without a hitch.

I did have to apply a little craft glue to the brooch to stabilise it once it was in place on the hat.

In part seven - adding ribbon to the back!

All ready at the front

Time to turn it into a brooch!

I figured out where I wanted the backing to go

My secret weapon...

...gives me a good idea where to pit the glue!

Fresh hot glue.

And moulded a little to make sure it all stays

Finally in its rightful place!